ADJ Products, LLC - www.adj.com - DMX Operator User Manual Page 17
UPLOAD USB DATA:
1. Insert your USB stick into the rear USB interface. Press and hold the AUTO/DEL BUTTON (8),
and press the BANK DOWN BUTTON (4).
2. The LED DISPLAY (3) will show “LOAD”.
3. The FIXTURE BUTTON LEDs which were saved on the USB stick will now glow.
4. Press the corresponding FIXTURE BUTTON (1) that you would like to reload the
corresponding settings to. After pressing the FIXTURE BUTTON, the backedup settings
will now load to the FIXTURE BUTTON.
FIRMWARE UPDATE:
Follow these simple instructions to update controller firmware.
1. Power OFF the controller.
2. Connect a compatible FAT 16 or FAT 32 formatted USB drive to a computer that has
downloaded the newest DMX Operator firmware.
Open the USB drive on the computer and create a folder named “DMX_OPERATOR”.
Add the downloaded firmware update file to the “DMX_OPERATOR” folder.
3. Properly eject the USB drive from the computer.
4. Insert the USB drive into the rear USB interface on the controller.
5. Press and hold the FIXTURE 1, FIXTURE 2 BUTTONS (1) and SCENE 3 BUTTON (2) and
while pressing these buttons, power ON the controller.
6. After about 3 seconds, the LED display should show “UPFR”. When this is displayed,
release the FIXTURE 1, FIXTURE 2 BUTTONS (1) and SCENE 3 BUTTON (2).
7. After releasing bothe FIXTURE BUTTONS (1) and SCENE 3 BUTTON (2), press any other
button on the controller to upload the new firmware file to the DMX Operator.
Backup Data / Upload Data / Firmware Update Using USB Stick
To Next Page
Loading...
