ADJ Products, LLC - www.adj.com - DMX Operator User Manual Page 20
DMX Operator Trouble Shooting
Listed below are a few common problems the user may encounter, with solutions.
Unit doesn’t respond when I move the faders
• Make sure address is correct.
• Make sure speed is adjusted, if available, for faster movement. Not all Fixtures have a speed
adjustment.
• If total of XLR cable is more than 90 feet make sure it is terminated properly.
Scenes don’t playback after I record them
• Make sure to press MIDI/RECORD BUTTON, before pressing SCENE BUTTON.
LED’s should blink after pressing each SCENE BUTTON.
• Make sure you are in the correct Bank that has scenes recorded.
Scenes don’t playback correctly like I recorded them
• Is the Fade Time to long for Speed selected?
• Make sure you are in the correct Bank that has scenes recorded.
• If total of XLR cable is more than 90 feet make sure it is terminated properly.
Chases don’t playback after I record them
• Make sure to press MIDI/RECORD BUTTON, after pressing SCENE BUTTON. LED’s should
blink after pressing MIDI/RECORD BUTTON.
• Make sure you are in the correct Chase that has steps recorded.
• If in Auto Mode, is It selected in Display? Did you adjust Speed after selecting Auto?
• Is Fade Time to long for Speed Selected?
• If total of XLR cable is more than 90 feet make sure it is terminated properly.
To Next Page
Loading...
