ADJ Products, LLC - www.adj.com - DMX Operator User Manual Page 11
DMX Operator Editing Scenes
SCENE COPY:
This function allows you to copy the settings of one scene to another.
1. Press the PROGRAM BUTTON (6) for three seconds to activate the Program Mode. The
LCD DISPLAY (3) will indicate Program Mode by displaying a continuous fast blinking dot
next to “PROG”.
2. Use the UP and DOWN BANK BUTTONS (4) to locate the bank / scene you wish to copy.
3. Press the SCENE BUTTON (2), that contains the scene you want to copy.
4. Use the UP and DOWN BANK BUTTONS (4) to select the bank you want to copy the scene to.
5. Press the MIDI / REC BUTTON (7) followed by the SCENE BUTTON (2) you wish to copy to.
SCENE EDITING:
This function allows you to make changes in a scene after it has been programmed.
1. Press the PROGRAM BUTTON (6) for three seconds to activate Program Mode.
The LCD DISPLAY (3) will indicate Program Mode by displaying a continuous fast blinking dot
next to “PROG”.
2. Use the UP AND DOWN BANK BUTTONS (4) to select the bank / scene that you wish to edit.
3. Select the scene you want to edit by pressing its SCENE BUTTON (2).
4. Use the FADERS (15) to make your desired adjustments.
5. Once you’ve made your changes, press the MIDI / REC BUTTON (7) followed by the SCENE
BUTTON (2) that corresponds to the scene your editing which will store the edited scene into memory.
Note: Be sure to select the same scene selected in step 4, otherwise you may accidentally record
over an existing scene.
RESET ALL SCENES:
This function will erase all scenes in all Banks. (ALL Channels of all scenes are reset to 0 output.
1. Press and hold down the PROGRAM button (6)
2. While holding down the PROGRAM BUTTON (6), press and hold the BANK DOWN BUTTON (4).
3. Disconnect the power from the controller and release the buttons.
4. Reconnect the power to the controller, and all scenes should be erased.
To Next Page
Loading...
