ADJ ELEMENT Series - Page 23

23
SYSTEM MENU
Operating Power:
This unit can be powered in two ways: battery power or AC power. Note: Regardless of the power
source, you need to activate the LOAD function.
AC Power - To operate the unit using AC power, plug it into a power source and activate the Load
setting. Make sure the Battery Switch is in the OFF position when using AC power.
Battery Power - To operate the unit using Battery power, switch the battery switch located on the
bottom of the xture to the “On” position, and activate the Load setting.
Load Setting:
The Load setting must be activated regardless of whether Battery power or AC power is used.
This switch activates the LED PCB output.
To activate Load, press the MODE button until either “bXXX,” “bsXX,” or “LoXX” is displayed. “XX”
represents the current setting of those menus.
Press the SETUP button until “LoXX” is displayed. “XX” represents either “on” or “oF” (Off).
Press the UP or DOWN buttons until “on” is displayed.
Energy Saving Mode:
This mode gradually decreases the brightness of the LED when the battery life is less than 80%,
extending the battery life.
To activate energy saving mode, press the MODE button until either “bXXX,” “bsXX,” or “LoXX” is
displayed. “XX” represents the current setting of the displayed menu.
Press the SETUP button until “bS:XX” is displayed. “XX” represents either “on” or “oF” (Off).
Press the UP or DOWN button until “on” is displayed. If “on” is already displayed, the xture is already
in energy saving mode.
Display Lock:
To set the LED display light to turn off after 20 seconds, plug in the xture and press the MODE button
until “dXX” is displayed. “XX” represents either “on” or “off”.
Plug in the xture and press the SETUP button until “LoCX” is displayed. “X” represents a number
between 1-3.
Press the UP or DOWN buttons to nd your desired setting.
“LoC1” - The keypad will always remain unlocked.
“LoC2” - The keypad will lock after 10 seconds. Press the MODE button for 3 seconds to unlock the
keypad.
“LoC3” - This lock setting is used to prevent accidental unlocking of the keypad. To unlock the keypad,
press UP, DOWN, UP, DOWN in that order.
LED Display On/Off:
To turn off the LED display light after 20 seconds, press the MODE button until “dXX” is displayed. “XX”
represents either “on” or “oFF”. Press the UP or DOWN buttons until “OFF” is displayed. The display
light will now turn off after 30 seconds. Press any button to turn the display on again.