EasyManua.ls Logo

ADJ FOCUS PROFILE - Installation and Environmental Considerations; IP Rating and Enclosure Protection; Flammable Material Warning; Electrical Connections and Daisy Chaining Rules

ADJ FOCUS PROFILE
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP RATING
This device is IP20 rated. It is protected against instrusion of solids larger than 12.5mm in size, or
approximately the size of an adult nger. The device is NOT protected against liquid instrusion of
any kind.
FLAMMABLE MATERIAL WARNING!
Keep device a minimum of 5.0 feet (1.5m) away from ammable material and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualied electrician should be used for all electrical connections and/or installations.
MULTI-DEVICE DAISY CHAINING
When connected to 240V power, up to 2 devices may be daisy chained together.
• When connected to 110V power, daisy chaining is NOT permitted. In this situation, only
operatethextureasasinglestandalonedevice!
DO NOT INSTALL THE DEVICE IF YOU ARE NOT QUALIFIED TO DO SO!
The unit MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations.
Before installing or mounting any device, a professional equipment installer MUST be consulted to
determine whether the mounting structure or surface is properly certied to safely support the com-
bined weight of the xture, clamps, cables, and accessories.
Overhead xture installations must always be secured with a secondary safety attachment, such as
an appropriately rated safety cable that meets all local, national, and country codes and regulations.
Maximum ambient operating temperature is 113°F (45°C). Do not operate this device when ambient
temperature exceeds this value.
This xture should be installed in areas outside walking paths, seating areas, and areas where unau-
thorized personnel might be able to reach the device by hand.
NEVER stand directly below the xture when rigging, removing, or servicing.
Allow approximately 15 minutes for the xture to cool down before servicing.
11
INSTALLATION

Related product manuals