11
FRONT PANEL CONTROLS AND FUNCTIONS
13. TAP SYNC: This button is used to create a chase rate. Repeatedly tapping this button will es-
tablish a chase rate that corresponds to your tap rate. The chase rate will be synchronized to the
time interval of the last two taps. A Tap Sync LED will ash at the established chase rate. A chase
rate may be set at anytime, whether a chase pattern is running or not. The Tap Sync Button also
activates Step Mode, by holding the Tap Sync button down for at least ve seconds. To deacti-
vate Step Mode, hold down the Tap Sync button again for ve seconds.
14. FULL ON BUTTON: This button is used to bring all channel outputs (1-16) to full intensity. This
function will override the Blackout (15) function. A Full On LED (14) will glow when Full On (14) is
active.
15. BLACKOUT BUTTON: This button is used to disable all channel outputs (1-16). Only the Full
On (14) and Bump Buttons (10) function can override this function. Blackout is active when the
Blackout LED is glowing.
16. FOG MACHINE BUTTON: This button is used to control fog output to a compatible ADJ fog
machine. Compatible models include the Master Blaster 700 and 1000, Vaporizer, and the Dyno
Fog. This button not only eliminates the need of a separate fog machine controller, but also al-
lows quick and easy access to a fog machine output. For an updated list of compatible fog ma-
chines, please contact our product support department.
17. CHASES 1-8: These buttons are used to access any of the eight user-created chases. A chase
LED will glow when a corresponding chase has been selected for operation.
To Next Page
Loading...
