Adtech ADTECH9 Series Programming Manual

ADTECH9 Series CNC Programming Manual
Note: In the program segment that compensation starts, there shouldn’t be arc instruction G02, G03, else it will
alarm (P/S69).
Action in compensation mode
In compensation mode, the same compensation instructions (G41/G42) do not require new setting; over cutting
or insufficient may occur if four or more continuous segments do not have motion instructions.
(1) Occasions that outer corner rotates

Adtech ADTECH9 Series Specifications

General

Brand	Adtech
Model	ADTECH9 Series
Category	Control Systems
Language	English