Adtech CNC9 Series - Page 177

ADTECH9 Series CNC Maintenance Manual
- 172 -
system alarm
017 Spindle Auto Open
Range : OFF ON
Unit : None
Authority : Operation admin or higher
Default : OFF
Effective time : Instant
Note : To set to automatically start the spindle when system executes the
machining program
018 Spindle Auto Stop
Range : OFF ON
Unit : None
Authority : Operation admin or higher
Default : OFF
Effective time : Instant
Note : To set to stop the spindle automatically when the system machining
program ends.
019 Analog spindle encoder a loop pulse number
Range : 0~10000000
Unit : None
Authority : Operation admin or higher
Default : 2500
Effective time : Instant
Note : The received wire number of the encoder when the spindle rotates one
circle;
Same as common axis encoder, it can only receive AB phase pulse, and
thus the wire number of the encoder must be pulses of one circle divided
by 4.