ADTECH9 Series CNC Maintenance Manual
- 123 -
ON: turn on this function; when turned on, execute program or
mechanical home in home mode, return to the value set by coordinate
parameters -Æ coordinate settings -Æ reference point 1.
048 Clear coordinates in home mode
Range : MAC Coord G54 Coord
Unit : None
Authority : Operation admin
Default : MAC Coord
Effective time : Instant
Note : For setting in home mode, press axis X, Y, Z, A, B, C in Run -Æ Absolute
position and the red LED flashes, press the [Cancel] button to clear the
coordinate system, press MAC Coord to clear machine coordinates, and
press G54 Coord to clear G54 workpiece coordinates. This function is
generally used for machine debugging. Do not use it if the machine has
been debugged.
049
Z-axis safe height
050 A-axis safe height
Range : -9999.999~9999.999
Unit : mm
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note : When P1.044 or P1.045 is enabled and set to workpiece coordinates or
machine coordinates, it is used to set the safety height automatically
lifted (workpiece coordinates or machine coordinates) when A-axis or
Z-axis pauses in the processing or executes home operation in home
mode.
051
Z axis feed rate limit
052 A axis feed rate limit
Range : 0~20000
To Next Page
Loading...
