ADTECH9 Series CNC Maintenance Manual
- 124 -
Unit : mm/min
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note : When Z-axis or A-axis is used as the cutting feed axis, it sets the
maximum G01 cutting feed rate.
053
Thread cutting acceleration pitch P (L series)
054 Thread cutting acceleration pitch D (L series)
055 Thread cutting backslide amount V (L series)
Range : 0~100
Unit : mm
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note : To set the pitch length of acceleration segment of lathe CNC4620 system
thread cutting command G32 & G92, pitch length of the deceleration
segment and run-out amount. For details of G32 G92 instruction, see
CNC4620 programming manual.
056 Reserved
Range : OFF ON
Unit : None
Authority : Operation admin
Default : OFF
Effective time : Instant
Note :
057 System home ON
Range : No, Ask, Auto
Unit : None
Authority : Operation admin
Default : Non-return-to-zero
To Next Page
Loading...
