ADTECH9 Series CNC Maintenance Manual
- 126 -
Range : 0~1
Unit : None
Authority : Operation admin
Default : 0
Effective time : Instant
Note : When the logic direction obtained by handheld box encoder is reverse to
the actual motion direction of the axis, set this parameter to perform
in-phase setting.
0: positive direction
1: negative direction
062 Handwheel control mode
Range : 0~1
Unit :
Authority : Operation admin
Default : 0
Effective time : Instant
Note : Used to set handwheel to control the motion of each axis; 0: old, 1: new
063 Handwheel max rate
Range : 500~10000
Unit :
Authority : Operation admin
Default : 4000
Effective time : Instant
Note : Used to set the maximum rate of handwheel (valid when P1.062 is set to
1).
064 Handwheel acceleration
Range : 1~20
Unit :
Authority : Operation admin
Default : 10
To Next Page
Loading...
