ADTRAN 600 Series User Manual

Total Access 600 Series User Manual © 2002, ADTRAN, Inc.
Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 52
The following settings are used for FRF5.
L
AN
FR M
AINT
P
ROTOCOL
Frame Relay maintenance or signaling protocol
between local V.35 port and the attached DTE
port, support ANSI Annex A, CCITT Q933 An-
nex D, CISCO LMI or Static (no signaling).
L
AN
FR P
OLL
T
IMEOUT
T392 (5-30)
T392 for signaling protocol, typical value 15. No
meaning if Maint Protocol is Static.
FRN P
ORT
C
ONFIG
Logical Frame Relay ports over ATM. Up to 4
ports are supported with each port supporting up
to 4 DLCI mappings. Go to
NUM
field. Typing "i"
or "I" will insert another entry, and typing "d" or
"D" will delete one entry.
N
AME
To identify your port.
ATM VPI
Specifies the virtual path over which this
logical port is running.
$709&,
Specifies the virtual circuit over which this
logical port is running.
D
E
M
AP
Frame Relay to ATM DE mapping; default
value (Frn Only, ATM 0) suggested.
&/3,0
$3
ATM to Frame Relay CLPI map; default
value (Frn Only) suggested.
'&
Set D/C field in the header to 0 or 1.
+
($'(5
Header format; only 2 bytes supported now.
0
$,17
3
5272&2/
Maintenance or signaling protocol over this
logical Frame Relay port. Support Annex A,
Annex D, CISCO LMI or Static.
0
8;
0
2'(
Many DLCIs or one DLCI mapping over this
port.
'/&,0
$3
Actual DLCI mappings.
/
$1
'/&,
The DLCI configured over local V.35
Frame Relay port.
1
(7
'/&,
The DLCI configured over the WAN
side logical Frame Relay port.
$
&7,9(
Always active, not configurable.

ADTRAN 600 Series Specifications

General

Brand	ADTRAN
Model	600 Series
Category	Switch
Language	English