ADTRAN Total Access 324 User Manual

1
jobAid
DESCRIPTION
This Job Aid covers two types of Single Family Unit (SFU) Optical
Network Terminations (ONTs): Outside ONTs (ONTs installed on the
outside of a customer’s residence--see Items 1 to 6 in the table below), and
Indoor ONTs (ONTs installed inside a customer’s residence--see Items 7
to 9 in the table below). This Job Aid supports the ONTs listed in the
following table.
The SFU ONT is part of a Gigabit Passive Optical Network (GPON). The
Total Access 300 Series ONT provides POTS and Ethernet interfaces, and
depending on the model, an RF interface.
To allow for the transmission of downstream and upstream traffic on one
single fiber, different wavelengths are used for each direction.
Downstream traffic uses 1490 nm (digital), while upstream traffic is
carried on 1310 nm. For RF TV distribution, a second downstream
wavelength of 1550 nm is used (video). Minimum and Maximum power
levels for RF Units is -8 dBm and +2 dBm respectively.
NOTE
The ONT in Figure 1 is a Total Access 362R 2nd Generation 2 POTS/2
Ethernet and one RF Return ONT. This typifies ONTs installed in a
Corning Network Interface Device (NID) housing. Figure 2 displays the
front and back of a Total Access 334 Single Family Unit with a UPS
connection. This model typifies ONTs installed inside the customer
premises.
Item Description Part Number CLEI
Outdoor ONTs
1 Total Access 351 2nd Generation 2
POTS/1 Ethernet SFU ONT
1287701G1 BVL3AP8D_ _
2 Total Access 352 2nd Generation 2
POTS/2 Ethernet SFU ONT
1287702G1 BVL3AP9D_ _
3 Total Access 352H 2nd Generation
SFU ONT
1287702G3 BVMB100F_ _
4 Total Access 362 2nd Generation 2
POTS/2 Ethernet/1 RF Overlay
SFU ONT
1287712G1 BVMB900F_ _
5 Total Access 364 2 POTS/4 Ether-
net/ 1 RF Overlay Outdoor ONT
1287713G1 NA
6 Total Access 362R 2nd Generation 2
POTS/2 Ethernet/1 RF Return SFU
ONT
1287715G1 BVMB300F_ _
Indoor ONTs
7 Total Access 324 SFU ONT 1287735G1 BVMB600F_ _
8 Total Access 324 SFU ONT with
UPS
1287735G2 BVMB700F_ _
9 Total Access 334 3rd Generation
SFU ONT with UPS
1287736G3 BVMBP10F_ _
Total Access 300 Series
Single Family Unit ONT
Figure 1. Outdoor ONT
NOTICE
In Figure 1, older models do not have access to the Power Connector from
the front of the module. To access the Power Connector on these units,
loosen the Telco Access screw and swing the module open.
Figure 2. Indoor ONTs
INSTALLATION GUIDELINES
NOTE
The Total Access 300 Series SFU ONT Installation and Maintenance Guide
(P/N 612877GONT-5) contains all information necessary to install, test,
and troubleshoot the ONTs supported in this Job Aid.
Surface Mounting
Hole
Surface
Mounting
Hole
Hinge
Hinge
Security
Screw
Two-screw
Terminal
Bridges
Ethernet
Connections
Fiber Optic
Cable
Ground
Power
Ethernet
POTS
Ground and Power
Drop Callout
Ground Drop
Fiber Drop
RING
TIP
RING
TIP
FXS 0/1
FXS 0/2
ETH 0/1
ETH 0/2
TIP
RING
ETH 0/1
ETH 0/2
POTS 1
POTS 2
POTS 2
POTS 1
TELCO ACCESS
ETH 1
TOTAL ACCESS 362
1287712G1
12V , 1.25A
POWER
NETWORK STATUS
TELEPHONE TROUBLESHOOTING
1. Identify the bad line.
2. Disconnect the plug from the appropriate POTS jack and plug
any working telephone into that jack.
If the telephone works, there is a problem inside the house.
If the telephone does not work, contact your service provider.
3. Remove the telephone and replace the plug into the POTS jack.
4. Close the unit.
CLEI
TEL. NUMBER
RF Connection
ETH 2
RF
+ 12VDC 12V RTN SIG RTN ON BAT REP BAT BAT MIS LOW BAT
7654321
Total Access 324
PHONE
PWR
NET
1
2
1
2
3
4
ETH
PHONE 1
PHONE 2
NET
1
23
ETHERNET
4
RF
LOW BAT BAT MIS
REP BAT
ON BAT
SIG RET 12V RET +12V
ON/OFF PWR UPS POTS1 POTS2 ETH1 ETH2 ETH3 ETH4 CATV
POWER BATTERY FAIL ETH4 ETH3 ETH2 ETH1 POTS MGMT WLAN
3rd Generation
Issue Date: February 2015
Document P/N: 612877GONT-22B
Documentation for ADTRAN Carrier Networks products is
available for viewing and download directly from the
ADTRAN Support Community website.
Go to: https://supportforums.adtran.com/welcome
Registration is required.
ADTRAN offers training courses on our products, including
customized training and courses taught at our facilities or at
customer sites.
For inquiries, go to: http://adtran.com/training
The following related online documents and resources provide additional information for this product:
Total Access 300 Series SFU ONT Installation and Maintenance Guide
Total Access 5000 GPON User Interface Guide
Total Access 5000 Series Fiber to the Premises Deployment Guide
Total Access 5000 Series BBDLC Deployment Guide
Total Access 5000/5006 Engineering Guide

ADTRAN Total Access 324 Specifications

General

Brand	ADTRAN
Model	Total Access 324
Category	Network Hardware
Language	English

Summary

Required Tools and Supplies

Outdoor ONT Installation

Mount the Enclosure

Steps to mount the outdoor ONT enclosure, including screw placement and sliding the unit.

Route Fiber Drop Cable

Instructions for routing the OptiTap fiber drop cable through the enclosure grommet.

Connect SC/APC Optical

Guidance on installing the SC/APC optical connection using a bulkhead adapter.

Install Local Power Source

Information on installing the Local Power Source (LPS) based on site conditions.

Install UPS

Details on installing the Uninterruptible Power Source (UPS) for ONT power.

Connect POTS

Procedure for connecting POTS lines using terminal bridges or RJ-11 connectors.

Connect RF

Instructions for routing the RF cable and connecting it to the ONT.

Connect Ethernet

Steps for connecting the subscriber Ethernet cable for Gigabit operation.

Indoor ONT Installation

Mount ONT

Guidance on selecting a location and mounting the indoor ONT below eye-level.

Connect POTS

Procedure for creating and connecting POTS cables to the indoor ONT.

Connect Ethernet

Instructions for connecting the 1 Gigabit Ethernet connections to the indoor ONT.

Connect RF Video

Guidance for connecting a standard male F-type connector coaxial cable for RF video.

Connect External Power

Instructions for connecting the external power supply to the indoor ONT.

ONT Status Indicators

LED Status Table

Details the status of POWER, NETWORK STATUS, and POTS 1-2 LEDs for ONTs.

Ethernet Link Status

Explains the status indicators (HPNA, ETH 1-4) for Ethernet and network link status.

Specifications and Maintenance

Operational Specifications

Lists key specifications including voltage, power consumption, weight, and optical parameters.

Maintenance

States that no routine hardware maintenance is required for normal operation.

Safety and Regulatory Compliance

Directs users to the Installation and User Guide for safety and compliance information.