Operating manual - English BRAVO III with EZ-Jaw
Copyright Silca 2010 9
3.1 Safety
• Cutter motor protection
ATTENTION: the cutter motor is protected from overheating by a device (inside the motor) that stops it when
it reaches a dangerous temperature.
This condition can occur when the machine motor is left on continuously, with high ambient
temperatures or in severe working conditions. If the cutter motor overheats it cuts out
automatically. In such cases proceed as follows:
a) turn off the master switch (C).
b) let the motor cool for at least 2 hours then use the machine normally.
• Start-up
The master switch (C) has a safety function that prevents untimely start-up when voltage returns after
a cut-out.
3.2
Technical Data
ELECTRICAL
PROPERTIES
: 120V - 60Hz - 200W
MOTOR: 1 speed single phase
CUTTING TOOL: Super Rapid Steel
MOVEMENTS: on permanently lubricated bearings and sintered, self-cleaning, self-
lubricating bushings
CLAMP: high precision, four sides
MAXIMUM
LENGTH OF CUTS: 42 mm
SAFETY DEVICES: motor start-up by means of carriage pick-up with gauges in the idle position
DIMENSIONS: width: 400 mm depth: 520 mm height: 280 mm
CUTTING NOISE: Lp (A) = 79 dB (A) - brass keys
NOISE POTENTIAL: Lw (A) = 90,5 dB (A) - steel keys
WEIGHT: 21 Kg.
To Next Page
Loading...