Advanced Diagnostics BRAVO III - Default Chapter; Table of Contents

To Next Page

To Previous Page

CONTENTS

GUIDE TO THE MANUAL ......................................................................................1

GENERAL INTRODUCTION .................................................................................2

1 TRANSPORT ...................................................................................................4

1.1 Packing .................................................................................................4

1.2 Transport ..............................................................................................4

1.3 Unpacking .............................................................................................4

1.4 Handling the machine ...........................................................................5

2 WORKING PARTS ..........................................................................................6

3 MACHINE DESCRIPTION ...............................................................................7

3.1 Safety ....................................................................................................9

3.2 Technical Data ......................................................................................9

3.3 Electric circuit ......................................................................................10

4 ACCESSORIES PROVIDED .........................................................................11

5 MACHINE INSTALLATION AND PREPARATION .......................................12

5.1 Checking for damage ..........................................................................12

5.2 Environmental conditions ....................................................................12

5.3 Positioning ..........................................................................................12

5.4 Description of work station ..................................................................13

5.5 Graphics .............................................................................................13

5.6 Separate parts ....................................................................................13

5.7 Connection to the mains .....................................................................13

5.8 Checking and setting ..........................................................................14

5.9 Calibration ...........................................................................................14

6 CUTTING OPERATIONS ..............................................................................16

6.1 Key cutting ..........................................................................................16

6.2 Cutting pin keys ..................................................................................17

7 CLEANING AND MAINTENANCE ................................................................18

7.1 Preparing for maintenance .................................................................18

7.2 Replacing the cutting tool ...................................................................18

7.3 Replacing the brush ............................................................................19

7.4 Replacing the tracer point ...................................................................19

7.5 Regulating of maximum carriage depth ..............................................20

7.6 Replacing the fuses ............................................................................20

7.7 Access to bottom compartment ..........................................................21

7.8 Replacing the master switch ...............................................................21

7.9 Replacing the condenser (motor) .......................................................22

7.10 Replacing the microswitch ..................................................................23

7.11 Replacing the switch and/or push button ............................................24

7.12 Replacing and/or tightening the belt ...................................................25

7.13 Replacing the single speed motor ......................................................26

7.14 Replacing carriage spring ...................................................................27

8 DISPOSING OF MACHINE ...........................................................................29