EN54 Sounder Resound Options
By default, after an initial fire condition and the (blue) Silence Alarms button has been activated, any new fire
condition in a different zone will cause the alarms to resound.
It is possible to change this on a zonal basis so that any new alarm in a different zone will not resound the
alarms.
Enter the above code and press the ENTER button. The Sounder Status LED will pulse slowly. Zone
Fault/Disabled/Test LEDs will show their current status (see below) with Zone 1 pulsing to indicate it is under
selection.
Use Button 1 to move to the zone for programming (indicated by a pulsing LED) and press the ENTER button to
change the status.
Pressing the ENTER button again will toggle the status, indicated by a rapid or slow pulsing LED (see below).
Then use Button 1 to move to the next zone. If the zone has been set to not resound alarms, the LED will be off.
If kept as default, new fire condition will resound alarms, then the LED will be on steady.
Rapid Pulse = Zone is under selection and is set to have alarms resound (default).
Slow Pulse = Zone is under selection and has been set to not resound alarms on new fire condition.
LED Off = Zone has been set to not resound alarms on new fire condition.
LED On = Zone is set to have alarms resound (default).
When finished, press and hold Button 1 for 3 seconds to save setting and exit programming mode
Enter the next programming code or disable the controls and return DIL switch 3 to ‘OFF’.
www.acornfiresecurity.com
www.acornfiresecurity.com
To Next Page
Loading...
Need help?
General
