Advantech Adam 4000 Series User Manual

Chapter 4 Command Set 4-19
Chapter 4
ADAM-4018 Command Table
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Set the address, input range, baud rate,
data format, checksum status and/or
integration time for the specified analog
input module
444
#AAN Read Analog Input
from Channel N
Return the input value from channels
number N of the specified analog input
module
454
#AA Read Analog Input
from all Channels
Return the input value from all
channels of the specified analog
module
4-52
$AA0 Span Calibration Calibrate the analog input module to
correct for gain errors
457
$AA1 Offset Calibration Calibrate the analog input module to
correct for offset errors
458
$AA2 Configuration
Status
Return the configuration parameters for
the specified analog input module
448
$AA5VV Enable/disable
Channels for
Multiplexing
Enables/disables multiplexing
simultaneously for seperate channels of
the specified input module
455
$AA6 Read Channel
Status
Ask the specified input module to
return the status of all eight channels
456
$AAF Read Version Return the firmware version code from
the specified analog input module
450
$AAM Read Module Name Return the module name from the
specified analog input module
451
$AA3 CJC Status Returns the value of the CJC sensor for
a specified analog input module
463
$AA9 CJC Offset
Calibration
Calibrates the CJC sensor for offset
errors
464

Advantech Adam 4000 Series Specifications

General

Brand	Advantech
Model	Adam 4000 Series
Category	Control Unit
Language	English