Advantech Adam 4000 Series - Page 107

Chapter 4 Command Set 4-23
Chapter 4
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Set the address, input range, baud rate,
data format, checksum status and/or
integration time for the specified analog
input module
444
#AAN Read Analog Input
from Channel N
Return the input value from channels
number N of the specified analog input
module
454
$AA0 Span Calibration Calibrate the analog input module to
correct for gain errors
457
$AA1 Offset Calibration Calibrate the analog input module to
correct for offset errors
458
$AA2 Configuration Status Return the configuration parameters for
the specified analog input module
448
$AA5VV Enable/disable
Channels for
Multiplexing
Enables/disables multiplexing
simultaneously for seperate channels of
the specified input module
455
$AA6 Read Channel
Status
Ask the specified input module to return
the status of all eight channels
456
$AAF Read Version Return the firmware version code from
the specified analog input module
450
$AAM Read Module Name Return the module name from the
specified analog input module
451
$AA3 CJC Status Returns the value of the CJC sensor for
a specified analog input module
463
$AA9 CJC Offset
Calibration
Calibrates the CJC sensor for offset
errors
464
ADAM-4018M Command Table
(continued on following page)