Advantech Adam 4000 Series - Page 108

Command Set
4-24 ADAM 4000 Series User's Manual
ADAM-4019 Command Table
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Sets the address, baud rate, data
format, checksum status, and/or
integration time for a specified analog
input module
4-44
#AAN Read Analog
Input from
Channel N
Returns the input value from a
specified channel of analog input
module in the currently configured
data format
4-54
#AA Analog Data In Returns the input value from a
specified analog input module in the
currently configured data format
4-52
$AA0Ci Single Channel
Span Calibration
Calibrates a specified channel to
correct for gain errors
4-65
$AA1Ci Single Channel
Offset Calibration
Calibrates a specified channel to
correct for offset errors
4-66
$AA2 Configuration
Status
Returns the configuration parameters
for the specified analog input module
4-48
$AA3 CJC Status Returns the value of the CJC sensor
for a specified analog input module
4-63
#** Synchronized
Sampling
Orders all analog input modules to
sample their input values and store
them in special registers
4-59
$AA4 Read
Synchronized
Data
Returns the value that was stored in
the specified module’s register after
the #** command
4-60
$AA5VV Enable/Disable
Channels for
Multiplexing
Enable or disable the individual
channels in an analog module
4-55
$AA6 Read Channel
Status
Get the enable/disable status of all
channels in an analog module
4-56
$AAAi CJC Setting Configure the CJC setting 4-75