2-2 ADAM 4000 Series User's Manual
Installation Guideline
This chapter provides guidelines to what is needed to set up and install an
ADAM network. A quick hookup scheme is provided that lets you config-
ure modules before they are installed in a network.
To help you to connect ADAM modules with sensor inputs, several wiring
examples are provided. Finally, you will find at the end of this chapter a
programming example using the ADAM command set.
Be sure to carefully plan the layout and configuration of your network
before you start. Guidelines regarding layout are given in Appendix E: RS-
485 Network.
NOTICE: Except for the communication modules, which have on-board
switches for their baud rate setting, ADAM modules should not be opened.
There is no need to open the ADAM modules: all configuration is done
remotely and there are no user serviceable parts are inside. Opening the
cover will therefore void the warranty.
To Next Page
Loading...
Need help?
General
