Chapter 5
Chapter 5 Calibration 5-3
Figure 5-3
Span Calibration
5. Execute the Span Calibration command. This can be done with the
ADAM utility software. (See “Span Calibration” option in the
Calibration sub-menu of the ADAM utility software).
4. Execute the Offset Calibration command. This is also done with the
ADAM utility software. (See “Offset Calibration” option in the Calibra-
tion sub-menu of the ADAM utility software).
Figure 5-2
Zero Calibration
To Next Page
Loading...
