AEG PROTECT 1 LCD - Page 36

Note:
1. Please select the larger cross-section conductor for the parallel system ‘AC IN
cable’ in the single source application.
2. In the three-phase output mode, if the load is an unbalanced load, the L wire
of the bypass and output may exceed the rated current, and the maximum
rated current will be 1.732 times. The corresponding protection device and
wiring cable must be determined according to the standards of the region and
the actual situation of the user.
4
44
4.
..
.1
11
1.
..
.2
22
2 Wiring for AC
Wiring for AC Wiring for AC
Wiring for AC c
cc
cable (AC source to UPS)
able (AC source to UPS)able (AC source to UPS)
able (AC source to UPS)
AC cable wiring are shown in below diagrams for different configuration.
 3-3 configuration (single source)