38
Do not connect any household appliances or power tools to the
UPS.
Never connect or switch on additional load
segments during a power outage, i.e. when the
UPS is operating in emergency power mode!
As a rule, if there has never been an overload in normal
operation, there won’t be an overload in battery mode.
If the malfunction LED lights up and you hear a
warning sound, there is a malfunction which
causes the system to shut down. Follow the
instructions provided in Chapter 9.1.
Then make sure that the wire jumper in the emergency shutdown
plug is firmly in place and tighten the two outside screws on the
plug (also see pg. 31, no. 7).
If you want to use the emergency power off function, continue
first with Chapter 8.4 on pg. 57.
The integrated emergency power off only serves to
shut off the UPS voltage. This happens
electronically and is not the same as an
EMERGENCY STOP system according to DIN EN
ISO 13850.
To Next Page
Loading...
