AEG PROTECT D LCD+ - Display functions

69
EN
4.3 Display functions
When starting the UPS, the display is in the default UPS status
summary screen.
Main menu Submenu
Display information or Menu
function
UPS status
UPS mode, date/time, battery status
and current alarms
Event log Displays the events and faults stored
Measurements
[Load] W VA A P%, [Input/Output] V Hz,
[Battery] % min V EBP, [DC Bus] V,
[Temperature] C
PUE, kWh
Control
Go to Bypass Transfers the UPS on Bypass mode
Load segment Load segment on/off
Start battery
test
Starts a manual battery test
Reset fault
state
Clear active fault
Reset event
list
Clear events and faults
Reset com
card
Reset Modbus TCP function inside UPS
Restore
factory
settings
Restore to default factory settings
Settings Refer to User settings
Identification
[Product name], [Serial number],
[firmware version], [IP/MAC address]