AEG PROTECT D LCD+ - User settings

70
4.4 User settings
Submenu
Available settings
Default settings
Password Can be changed by user 4732
Change language
English, Italiano, Français, Deutsch,
Español, Русский, Polski,
简体中文
English
User password [enabled, ****], [disabled] enabled
Audible alarms [enabled], [disabled] enabled
Output voltage [200V], [208V], [220V], [230V], [240V] [230V]
Output frequency [autosensing], [converter 50Hz, 60Hz] autosensing
High efficiency mode [disabled], [enabled] disabled
Auto bypass [disabled], [enabled] disabled
Start/Auto
restart/Start from
bypass
[disabled], [enabled]
Cold start/Auto
restart: enabled
Start from bypass:
disabled
Site wiring fault [enabled], [disabled] disabled
Overload pre-alarm [10%~100%] 100%
External battery
[Auto detection],
[Manual EBP: 0~6],
Auto detection
Charger current
[2A], [4A], [6A], [8A] for long backup
model
4A
Dry in signal
[Disabled], [Remote on], [Remote off],
[Forced bypass]
disabled
Dry out signal
[load powered], [on bat], [Low bat], [bat
open], [bypass], [ups ok]
bypass