AEG PROTECT D LCD+ - Page 71

71
EN
Submenu
Available settings
Default settings
Ambient temperature
alarm
[enabled], [disabled] enabled
Battery remaining
time
[enabled], [disabled] enabled
Date and time dd/mm/yyyy hh:mm 01/01/2020 00:00
LCD contrast [-5 ~ +5] [0]
Modbus TCP [enabled], [disabled] disabled
Control commands [enabled], [disabled] enabled
Battery saving mode [disabled], [10%], [20%], …, [100%] disabled
REPO input polarity [normally open], [normally closed] Normally closed
Reset Consumption
When “yes” is selected the Cumulative
Consumption kWh value is cleared and
the Date & Time stamp for this statistic
is set to the current date & time.
“no”
Bat % to restart [0%], [10%], [20%], …, [100%] 0%
If the load type is a transformer type, it is recommended to enable
the “start from bypass” function.