DECT Settings
19
8 DECT Settings
8.1 Handset Settings
Handset settings allows you to view and modify the settings of your handset.
8.1.1 Registering your Voxtel Smart 3 to the base station
Your Voxtel Smart 3 handset has been pre-registered to the Base station by factory
default. If you have another Voxtel Smart 3 handset, you can follow the procedures here
to register it to the same Base station to form a multiple handset network.
1 Press and hold
N on the base station for about 4 seconds until the In Use / Message
LED light turns on.
2 Release
N.
3 On your Voxtel Smart 3, press
H.
4 Tap Settings > Dect Settings > Handset Settings > Registration.
5 Tap Base 1 and tap Register.
- The Voxtel Smart 3 will start to search for the base station.
6 Tap on Enter Pin box to launch the onscreen keyboard.
7 Enter the PIN code of the base station and tap Register.
- If successful, “Success” is displayed.
Note
If the PIN for the base station is set as "0000" (default), the Voxtel Smart 3 will register to
the base station without prompting for the PIN.
8.1.2 Registering your Voxtel Smart 3 to another base station
You can register your Voxtel Smart 3 handset to more than one base, and the base station
to which you wish to register the Voxtel Smart 3 must have a FREE handset location. You
must also know the PIN code of the base.
1 Press and hold
N on the base station for about 4 seconds until the In Use / Message
LED light turns on.
2 Release
N.
3 On your Voxtel Smart 3, press
H.
4 Tap Settings > Dect Settings > Handset Settings > Registration.
5 Tap to select the base number and tap Register.
- The Voxtel Smart 3 will start to search for the base station.
To Next Page
