AerAtron FR3 - Important Information

Important information - Please read before attempting installation
1
!
This fan must be installed by a licensed and qualified
electrician according to local authority regulaons.
*DIY installaon allowed in some countries*
1. Please read these instrucons carefully, be mindful of all warnings and safety informaon shown throughout
this manual. Should you have any quesons please call your local agent.
2. Please review the accompanying assembly diagrams before aempng installaon.
3. This fan MUST be installed by a licensed & qualified electrician according to local authority regulaons and in
accordance with current wiring rules of the country/state.
4. A copy of the purchasing receipt and proof of installaon by a licensed and qualified electrician according to
local authority regulaons is required for all warranty claims.
4a. DIY installaon requires proof of purchase only.
5. Where special access equipment is required to service the fan in accordance with local authority regulaons all
associated costs are the responsibility of the owner.
6. Should a warranty claim be required, we reserve the right to charge a service fee for all call outs where the
fan is found not to be defecve and / or where access is not provided.
7. To enable future programming, maintenance, cleaning and troubleshoong an isolaon switch per fan is highly
recommended. Without an isolaon switch per fan, an electrician maybe required to assist with programming,
maintenance, cleaning and troubleshoong. All associated costs are the responsibility of the owner.
8. A Maximum of 8 fans on each RCD / circuit is recommended. The fans are a Class 5 Device with leakage to
Earth.
9. Your warranty will be void if a solid state dimmer or any other brand of wall controller is used.
10. The means for mains power disconnecon must be incorporated in the fixed wiring in accordance with
naonal wiring rules.
11. To avoid possible electric shock during installaon, be sure electricity is turned off at the main power box
before commencing work. Disconnect power by removing fuse or turning off circuit breaker before installing
the fan. Ensure all spliced connecons are adequately insulated.
12. Warning! Do not allow the rotang fan blades to come into contact with any object, this can cause serious
injury or death.
13. Damage caused by incorrect installaon, Force-majeure, lightning, electrical surges & spikes, exposure to
water, pests or moisture is not covered under warranty.
14. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilies, or lack of experience and knowledge, unless they have been given supervision or instrucon
concerning use of the appliance by a person responsible for their safety.
15. Suspension System
· the replacement of parts of the safety suspension system device shall be performed by the manufacturer, its
service agent, or suitably qualified persons.
· fixing means for aachment to the ceiling such as hooks, or other devices shall be fixed with a sufficient
strength to withstand 4 mes the weight of the ceiling fan.
· the mounng of the suspension system shall be performed by the manufacturer, its service agent, or suitably
qualified persons
· the model or type reference of a luminaire that may be installed in a fan must be constructed for this purpose
Australia, New Zealand: In accordance with AS/NZS60355-1 & ASNZS60355-2-80: “This appliance is not
intended for use by persons (including children) with reduced physical, sensory or mental capabilies, or lack
of experience and knowledge, unless they have been given supervision or instrucon concerning use of the
appliance by a person responsible for their safety. Children should be supervised to ensure that they do not
play with the appliance.”