Need help?Do you have a question about the AERMEC ANKI 020 and is the answer not in the manual?
Logos and standards for company quality management systems.
Logos and standards for product safety compliance.
Key safety guidelines for installation, operation, and maintenance.
Steps to mitigate risks like electric discharge, moving parts, and sharp edges.
Visual warnings and required personal protective equipment for safe operation.
Safety actions including unit placement, fluid handling, and electrical checks.
Instructions for safe movement and care of the unit during transport.
Checks upon receipt and identifying unit details via packaging and technical plate.
Safe methods for lifting and positioning the unit using suitable belts or forklifts.
Procedures for keeping units in storage before installation.
Site selection, base preparation, and spacing for proper unit installation.
Location and dimensions for installing anti-vibration supports.
Layout and adapter details for water and gas connections.
Best practices for piping, filters, expansion tanks, and pressure relief.
Procedures for emptying the unit to prevent freezing during winter.
Methods and precautions for protecting the unit against freezing.
Standard and installer-provided components in hydraulic circuits.
Table detailing acceptable water characteristics for the system.
Safety and regulatory requirements for electrical hook-up.
Table of electrical ratings (LRA, MCA, MOP) for different models.
Graph showing operating limits for cooling based on air and water temperatures.
Graph showing operating limits for heating based on air and water temperatures.
Initial steps and safety checks before unit operation.
Verification steps during unit operation and final commissioning.
Overview of safety, risks, PPE, regulations, and hazard mitigation.
Procedures for specific risks, cleaning, inspection, and testing operations.
Routine checks for leaks, power, valves, filters, and cleaning.
Tasks for cooling circuit and compressor health.
Inspection of pumps, pipes, heat exchangers, and filters.
Verifying compressor, electrical, electronic, and cooling circuit parts.
Safe recovery of refrigerants and disposal of components.
Overview of available accessories like MOD485K, PGD1, PR3, VT, BDX.
Logos and standards for company quality management systems.
Logos and standards for product safety compliance.
Key safety guidelines for installation, operation, and maintenance.
Steps to mitigate risks like electric discharge, moving parts, and sharp edges.
Visual warnings and required personal protective equipment for safe operation.
Safety actions including unit placement, fluid handling, and electrical checks.
Instructions for safe movement and care of the unit during transport.
Checks upon receipt and identifying unit details via packaging and technical plate.
Safe methods for lifting and positioning the unit using suitable belts or forklifts.
Procedures for keeping units in storage before installation.
Site selection, base preparation, and spacing for proper unit installation.
Location and dimensions for installing anti-vibration supports.
Layout and adapter details for water and gas connections.
Best practices for piping, filters, expansion tanks, and pressure relief.
Procedures for emptying the unit to prevent freezing during winter.
Methods and precautions for protecting the unit against freezing.
Standard and installer-provided components in hydraulic circuits.
Table detailing acceptable water characteristics for the system.
Safety and regulatory requirements for electrical hook-up.
Table of electrical ratings (LRA, MCA, MOP) for different models.
Graph showing operating limits for cooling based on air and water temperatures.
Graph showing operating limits for heating based on air and water temperatures.
Initial steps and safety checks before unit operation.
Verification steps during unit operation and final commissioning.
Overview of safety, risks, PPE, regulations, and hazard mitigation.
Procedures for specific risks, cleaning, inspection, and testing operations.
Routine checks for leaks, power, valves, filters, and cleaning.
Tasks for cooling circuit and compressor health.
Inspection of pumps, pipes, heat exchangers, and filters.
Verifying compressor, electrical, electronic, and cooling circuit parts.
Safe recovery of refrigerants and disposal of components.
Overview of available accessories like MOD485K, PGD1, PR3, VT, BDX.
To Next Page
General
