To Next PageTo Next Page
Need help?Do you have a question about the AERMEC ANK 020-085 HA and is the answer not in the manual?
Identifies the ANK unit via packing label or technical plate.
Details of compressors, system side heat exchanger, and water features.
Details water filter, flow switch, safety valve, and air vent valve.
Lists safety components like high pressure switch and control board.
Details the electric control board, door-lock switch, and control keyboard.
Graph showing operating limits based on external air and water temperatures.
Graph showing operating limits based on external air and water temperatures.
Details cooling capacity and input power for ANK 020 H (230V).
Details cooling capacity and input power for ANK 020 HP/HA (230V).
Details cooling capacity and input power for ANK 020 H (400V).
Details cooling capacity and input power for ANK 020 HP/HA (400V).
Details cooling capacity and input power for ANK 030 H (400V).
Details cooling capacity and input power for ANK 045 H (230V).
Details cooling capacity and input power for ANK 040 H (400V).
Details cooling capacity and input power for ANK 050 H (400V).
Details cooling capacity and input power for ANK 085 H (400V).
Graph and table for pressure drops in the system plus pipes side exchanger.
Graph illustrating useful heads available to the system at different water flow rates.
Guide on how to use graphs to find glycol percentage and correction coefficients.
Lists minimum, maximum, and default calibration values for safety and control parameters.
Instructions on providing and preserving documentation for the user.
Guidelines for safe installation by qualified technicians, warning against modifications.
Diagram and component list for the standard ANK H hydraulic circuit.
Diagram and component list for the ANK HP hydraulic circuit.
Diagram and component list for the ANK HA hydraulic circuit.
Diagrams illustrating minimum required installation spaces around the unit.
Diagrams showing hydraulic connection points for ANK 020 H and HP models.
Diagrams showing hydraulic connection points for ANK 030-085 H and HP models.
Diagram showing hydraulic connection points for ANK 020 HA model.
Diagrams showing hydraulic connection points for ANK 030-085 HA models.
Instructions for connecting the unit to the main power supply, including safety precautions.
Details on connecting remote controls, alarms, and other external devices to the unit.
Notes on system readiness and service requirements before commissioning.
Steps for initial unit setup, checks before powering, and checks after powering.
Instructions for changing the unit's operating season (summer/winter).
Procedure to set the operating season directly on the unit's interface.
Details the factory-set temperature and differential for cooling mode.
Details the factory-set temperature and differential for heating mode.
Explains the minimum time delays set for compressor start-up to prevent issues.
Details the anti-freeze protection mechanism and manual reset procedure.
Explains the water flow rate monitoring and alarm system for compressor and pump protection.
Checks and maintenance procedures for the hydraulic circuit, water filter, and glycol.
Checks for safety devices, voltage, absorption, connections, and compressor resistance.
Checks for compressor state, heat exchanger efficiency, pressure, and filter dryer.
Step-by-step guide to accessing and modifying user parameters using the control panel.
Procedure to access and modify installer parameters with the correct password.
Lists causes and remedies for the unit failing to start, including voltage and switch issues.
Details causes of compressor shutdown due to over/under pressure, voltage, or temperature, and related fixes.
Identifies causes and remedies for high intake pressure, like external temperature or thermostatic valve issues.
Lists causes and remedies for low intake pressure, such as insufficient water flow or thermostatic valve problems.
General
