Need help?Do you have a question about the AERMEC ANL 150-HP and is the answer not in the manual?
Explanation of control and safety components like pressure switches and transducers.
Details on the electrical panel, its components, and safety features.
Defines the operating limits for the cooling mode.
Defines the operating limits for the heating mode.
General introduction to unit hazards and manual usage.
Recommended PPE for handling, installation, and maintenance.
Fundamental safety rules for personnel and unit operation.
Safety measures for hydraulic circuit connections and fluid handling.
Safety measures for electrical connections and wiring.
Safety measures for refrigerant circuit handling and potential leaks.
Procedures for inspecting the unit upon receipt.
Minimum clearances required for single unit installation.
Guidelines for connecting hydraulic circuits to the unit.
Mandatory electrical safety requirements and connections.
Initial startup procedures and warnings.
Checks to perform before applying power to the unit.
Procedures and checks while the machine is operating.
General precautions and safety measures for maintenance.
Safety measures for mechanical risks during maintenance.
Safety measures for chemical, fire, and environmental hazards.
Safety measures for pressure and temperature related risks.
Procedures for inspecting and controlling the unit.
Explanation of control and safety components like pressure switches and transducers.
Details on the electrical panel, its components, and safety features.
Defines the operating limits for the cooling mode.
Defines the operating limits for the heating mode.
General introduction to unit hazards and manual usage.
Recommended PPE for handling, installation, and maintenance.
Fundamental safety rules for personnel and unit operation.
Safety measures for hydraulic circuit connections and fluid handling.
Safety measures for electrical connections and wiring.
Safety measures for refrigerant circuit handling and potential leaks.
Procedures for inspecting the unit upon receipt.
Minimum clearances required for single unit installation.
Guidelines for connecting hydraulic circuits to the unit.
Mandatory electrical safety requirements and connections.
Initial startup procedures and warnings.
Checks to perform before applying power to the unit.
Procedures and checks while the machine is operating.
General precautions and safety measures for maintenance.
Safety measures for mechanical risks during maintenance.
Safety measures for chemical, fire, and environmental hazards.
Safety measures for pressure and temperature related risks.
Procedures for inspecting and controlling the unit.
To Next Page
General
