AERMEC C-TOUCH - Setting the Secondary Set-Point and Recovery (if available); Setting the Outside Temperature for Automatic Changeover; Setting the Operating Mode on the Basis of the Calendar

15
6.2 SETTING THE SECONDARY SETPOINT AND RECOVERY
IF AVAILABLE
1. Setpoint 2:
Indicates the current value of the secondary cooling set-point;
Indicates the current value of the secondary heating set-point (on heat pump only);
2. Recovery Enable Setpoint:
Indicates the current setting for recovery (YES = recovery enabled; NO = recovery
disabled);
Indicates the current value of the recovery set-point (if installed);
6.3 SETTING THE OUTSIDE TEMPERATURE FOR
AUTOMATIC CHANGEOVER
— Indicates the current outside air temperature at which cooling mode will be
activated;
— Indicates the current outside air temperature at which heating mode will be
activated (on heat pump only);
6.4 SETTING THE OPERATING MODE ON THE BASIS OF THE
CALENDAR
— Indicates the day of the month on which cooling mode will be activated
— Indicates the month in which cooling mode will be activated
— Indicates the day of the month on which heating mode will be activated (heat
pump only)
— Indicates the month in which heating mode will be activated (heat pump only)