Aeroflex PSD60-2R - Page 12

Aeroflex Operation Manual
PSD60-2R – REV 01 – SEPTEMBER 30, 2010 – PAGE 1-4
J5 TANK UNITS HI-Z Allows connection from test set measurement circuits to aircraft
tanks.
P6 TANK UNITS COMP Allows connection from test set measurement circuits to aircraft
tanks.
J7 CHASSIS Access to PSD60-2R chassis ground. Normally
required to connect the PSD60-2R to aircraft ground.
S5 FREQUENCY SELECT Use to enter the LO-Z frequency. Also used to calibrate the
unit
S6, S7
& S8
TU DECADE
CAPACITOR
Increments TU SIMULATOR by 10, 100, or 1000 pF
increments depending on decade chosen (increments are not
calibrated)
S9 &
S10
COMP DECADE
CAPACITOR
Increments COMP SIMULATOR by 10 or 100 pF increments
depending on decade chosen (increments are not calibrated)
S11 CAPACITANCE
MEASUREMENT
MODE
Used to select between measuring Mode B (magnitude
capacitance) and Mode A (parallel capacitance).
C1 TU FINE Rotate for fine adjustment of TU simulation capacitance.
C2 COMP FINE Rotate for fine adjustment of COMP simulation capacitance.
NOTE:
C1 and C2 have 180 degree rotation for minimum to maximum value with no stops. It is
therefore possible to have an increasing value in either the clockwise or counter clockwise
direction.
TABLE 1-1