Aeroflex PSD60-2R - Default Chapter; Table of Contents

Aeroflex Operation Manual
PSD60-2R – REV 01 – SEPTEMBER 30, 2010 – PAGE T-1
TABLE OF CONTENTS
SECTION I
GENERAL INFORMATION
SECTION PAGE NUMBER
1.1 INTRODUCTION ........................................................................................ 1-1
1.2 EQUIPMENT DESCRIPTION..................................................................... 1-2
1.3 UNPACKING AND INSPECTING EQUIPMENT ........................................ 1-5
1.4 SPECIFICATIONS...................................................................................... 1-5
1.5 ACCESSORIES SUPPLIED ....................................................................... 1-6
1.6 EQUIPMENT REQUIRED BUT NOT SUPPLIED....................................... 1-6
SECTION II
OPERATION
2.1 GENERAL INFORMATION......................................................................... 2-1
2.2 CAPACITANCE MEASURMENT................................................................ 2-1
2.3 CAPACITANCE SIMULATION ................................................................... 2-2
2.4 RESISTANCE MEASURMENT .................................................................. 2-3
2.5 DTF MEASURMENT .................................................................................. 2-3
2.6 ERROR CODES ......................................................................................... 2-3
SECTION III
THEORY OF OPERATIONS
3.1 GENERAL THEORY OF OPERATIONS.................................................... 3-1
SECTION IV
MAINTENANCE
4.1 GENERAL MAINTENANCE........................................................................ 4-1
4.2 BILLS OF MAT, ASSY DWGS, SCHEMATICS & TEST PROCED............ 4-1
APPENDIX A
THREE TERMINAL MEGGER
A.1 PSD60-2R THREE TERMINAL MEGGER ................................................. A-1