Aeroflex PSD60-2R - Section 4: Maintenance; General Maintenance Procedures; Maintenance Documentation

Aeroflex Operation Manual
PSD60-2R – REV 0 – JANUARY 12, 2007 – PAGE 4-1
SECTION IV
MAINTENANCE
4.1 GENERAL MAINTENANCE
CLEANING WARNING:
Keep the equipment dry to avoid damage to the equipment. To prevent damage,
never apply solvents to the equipment housing. For cleaning, wipe the
equipment with a cloth that is lightly dampened with water, mild detergent, or
alcohol. Do not use aromatic hydrocarbons, chlorinated solvents, or methanol-
based fluids.
CAUTION: THE PSD60-2R CONTAINS ESD SENSITIVE DEVICES. OPEN AND
CALIBRATE AT ESD PROTECTED AREA ONLY.
A. Battery Replacement:: a "LO BAT" indication will illuminate on the digital display
when batteries require replacement. Remove the front panel and replace used
batteries with fresh alkaline batteries.
B. Calibration: The suggested calibration interval is 1 year. A test procedure,
JPN 04-0597-00 is included in the PSD60-2R Maintenance Manual (PN: 06-0597-00
for hard copy, E6-0597-00 for CD) available separately from Aeroflex. It contains a
section that tests the units accuracy, a section that calibrates the unit, and a section
that does complete testing of the unit. Periodic calibration and certification service is
also provided by:
Aeroflex
400 New Century Parkway
New Century KS 66031
Telephone: (800) 237-2831 / (913) 764-2452
Attn: Service Dept.
4.2 BILLS OF MATERIAL, ASSEMBLY DRAWINGS, SCHEMATICS & TEST
PROCEDURE
To assist in the maintenance of the PSD60-2R, bills of material, assembly drawings, schematics and
a test procedure are included in in the PSD60-2R Maintenance Manual (PN: 06-0597-00 for hard
copy, E6-0597-00 for CD) available separately from Aeroflex.