Aeroflex Operation Manual
SAFETY AND REGULATORY INFORMATION
PSD60-2R - REV. 0 – JANUARY 12, 2007 – PAGE 3
Fuse Symbol. To indicate a fuse.
Warnings
WARNING Do not use the equipment in a manner not specified in this manual!
WARNING Equipment should only be serviced by authorized personnel.
CLEANING WARNING
Keep the equipment dry to avoid damage to the equipment. To prevent damage,
never apply solvents to the equipment housing. For cleaning, wipe the
equipment with a cloth that is lightly dampened with water, mild detergent, or
alcohol. Do not use aromatic hydrocarbons, chlorinated solvents, or methanol-
based fluids.
DO NOT OPERATE IN EXPLOSIVE ATMOSPHERES
To avoid explosion, do not operate the equipment in an atmosphere of explosive
gas.
WARNING Equipment contains no-rechargeable batteries. Use only 1.5-V size C alkaline
cells. Never attempt to recharge these cells.
NOTE For EMC testing M17/84-RG223 double shielded coaxial cable, 4.5 m long, with
BNC connectors, shielding terminated 360° at both end connectors, and
unterminated at far end were used at terminals (ports) INDICATOR LOZ (J1),
INDICATOR HIZ (J2), INDICATOR COMP (J3), TANK UNITS LOZ (J4), TANK
UNITS HIZ (J5), AND TANK UNITS COMP (J6).
CAUTION This equipment is electrostatic discharge (ESD) sensitive. Use of the supplied
ESD wrist strap with cord (JPN 90-0283-02), or equivalent, must be used at all
times when operating this unit. See the manufacturer’s instructions that come
with each package for proper connection and use.
To Next Page
Loading...
