EasyManua.ls Logo

Aerospool WT-9 Dynamic - Page 31

Default Icon
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WT-9 Dynamic Club S FLIGHT MANUAL Section 4 Page 4-
8
4.5.1 Before starting engine
1. Ignition - both circuits switched off
3. Rudder pedals - freedom of movement
4. Control stick - freedom of movement
5. Throttle lever - freedom of movement, set to idle position
6. Elevator trim control - set neutral position
7. Fuel quantity - check
8. Instruments - setting and check up of the value
9. Radio - function check
10. Seat and safety harness - adjust and lock
11. Break - function check
12. Canopy of cockpit - shut and latched
4.5.2 Engine starting
Cold engine:
1. Brakes - set on parking position
3. Master switch - switched on
4. Starter key - switch to 1. position
5. Fuel cock - select left tank
6. Fuel pump - switch on and establish fuel pressure then switch off
7. Choke - open
8. Throttle lever - set to idle position
9. Ignition - both circuits switched on
10. Starter key - actuate, activate starter for max. 10 sec only
without interruption
11. As soon as engine runs - adjust throttle lever to achieve smooth running
at approximately 2000 r.p.m, check if oil
pressure has risen within 10 sec to 2 bar and
monitor oil pressure, choke off
12. Warming up - start warming up period at 2000 r.p.m for
approx. 2 minutes, continue at 2500 r.p.m,
duration depending on ambient temperature,
until oil temperature reaches 50
o
C
Warm engine: if the engine is already at operating temperature
Date: 1.12.2001 „Appr“

Other manuals for Aerospool WT-9 Dynamic

Related product manuals