AGFA d-lab.1 User Manual

Modification Capacitor Kit d-lab.1
12 CM+9.8072.9003.0 AGFA d-lab.1
3.5.4 Reinstallation of the LCD driver board
The resinstallation has to be done very carefully, otherwise fluctiations of the print quality will come up.
Before you install the heat sink on the board, put some heat sink compount on all 4 ICs and on the heat sink.
When you fix the screw of the heat sink, be careful. The torque limit is 0.13 Nm only!
Again be very careful with the connector of the flat cable. Push the cable into the connector and then lock it.
Finally mount all parts in reversed order of dismounting.

AGFA d-lab.1 Specifications

General

Brand	AGFA
Model	d-lab.1
Category	Printer
Language	English