AGFA DX-D 100 - Page 36

DX-D 100 Mobile X-ray Unit
User Manual
28
0188K EN 20201116
It is customer responsibility to assure that this equipment
and vicinity equipment complies the value of radio frequency
interferences shown in General Regulation for safety
according to IEC 60601-1-2:2007 and IEC 60601-1-2:2014
Tables as described in this section.
The manufacturer is not responsible for any interference
caused by using other than recommended interconnect
cables or by unauthorized changes or modifications to this
equipment.
GUIDANCE AND MANUFACTURER’S DECLARATION - ELECTROMAGNETIC EMISSIONS
(IEC 60601-1-2:2007 AND IEC 60601-1-2:2014)
This X-ray System is intended for use in the electromagnetic environment specified below.
The customer or the user of this X-ray System should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment -- guidance
RF emissions
CISPR 11
Group 1
This X-ray System uses RF energy only for its
internal function. Therefore, its RF emissions are
very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
CISPR 11
Class A
T
h
i
s
X
-
r
a
y
S
y
s
t
e
m
i
s
s
u
i
t
a
b
l
e
f
o
r
u
s
e
i
n
a
l
l
Harmonic emissions
IEC 61000--3--2
Class A
T
h
i
s
X
-ray
S
ystem
i
ssu
i
ta
b
l
e
f
or use
i
na
l
l
establishments other than domestic and those
directly connected to the public low--voltage power
supply network that supplies buildings used
f
or
Voltage fluctuations/flicker emissions
IEC 61000--3--3
Complies
s
u
p
p
l
y
n
e
t
w
o
r
k
t
h
a
t
s
u
p
p
l
i
e
s
b
u
i
l
d
i
n
g
s
u
s
e
d
f
o
r
domestic purposes.
NOTE - I n accordance with Standard IEC 60601-1-2:2014, the emissions characteristics of this equipment make it suitable for use in industrial areas and
hospitals (CISPR 11 Class A). If it is used in a residential environment (for which CISPR 11 Class B is normally required) this equipment might not offer
adequate protection to radio-frequency communication services. The user might need to take mitigation measures, such as reloc ating or re-orientating the
equipment.