Agilent Technologies 1290 infinity - Assembling the Pump Head

41
Pump Head Maintenance (Binary and High Speed Pumps)
2
Assembling the Pump Head
Assembling the Pump Head
For a detailed overview of the used parts refer to “Primary Pump Head with Seal Wash
(Binary Pump)” on page 16 and “Secondary Pump Head With Seal Wash (Binary
Pump)” on page 26.
When Before installing the pump head.
Tools required p/n Description
Pump head alignment tool
G4220-20012 Torque wrench 2 – 25 Nm
G4220-20013 4 mm hex bit
G4220-20041 Bit Torx 10x25 mm
G4220-20015 Adapter ¼ in square to hex
01018-23702 Insert tool
Parts required p/n Description
G4220-68741 1290 Binary Pump PM kit includes seal cap assemblies, PE piston seals and
PTFE frits
CAUTION
Damage of the pump piston
The pump piston is very sensitive to shearing forces from the side.
➔ Use the alignment piston of the pump head alignment tool for the alignment
procedure described below.
CAUTION
Wrong orientation of pins on support ring
Assembling the pump head without paying attention to the correct orientation of the
pins on the support ring can lead to leaks or damage of the piston and pump head.
➔ Observe pins on the support ring, which help assembling the parts of the pump
head in the correct orientation.