Autoscale and Run/Stop Controls
Autoscale Button
2-70
After the Autoscale button is pressed the oscilloscope is configured to the
following default control settings.
Table 2-35
Menu Settings
Display format Y-T
Sampling mode Real time
Acquire mode Normal
Vertical coupling Adjust to AC or DC according to the waveform
Vertical "V/div" Adjusted according to the waveform
Vertical Knobs Coarse mode
Bandwidth limit OFF
Waveform invert OFF
Horizontal position Center
Horizontal "S/div" Adjusted according to the waveform
Trigger type Edge
Trigger source Lowest numbered active channel
Trigger coupling DC
Trigger voltage Midpoint (50%) setting
Trigger sweep Auto
To Next Page
Loading...
