3-6
Specifications and Characteristics
Characteristics
Measurements
Automatic Measurements
Voltage Peak-to-Peak (Vpp), Maximum (Vmax), Minimum (Vmin), Average (Vavg), Amplitude
(Vamp), Top (Vtop), Base (Vbase), Overshoot, Preshoot, RMS (Vrms)
Time Frequency (Freq), Period, Positive Pulse Width (+Width), Negative Pulse Width (-Width),
Positive Duty Cycle (+Duty), Minus Duty Cycle (-Duty), Rise Time, Fall Time, Rising Edge
Time Delay from Channel 1 to Channel 2 (Delay1
→2 ), Falling Edge Time Delay from
Channel 1 to Channel 2 (Delay1
→2 ), Hardware Counter
General Characteristics
Physical:
Size
Weight
350 mm wide x 288 mm high x 145 mm deep (without handle)
4.8 kgs
Calibrator Output Frequency 1 kHz; Amplitude 3 Vpp into 1 M
Ω load
Power Requirements
Line Voltage Range 100 to 240 VAC ±10%, CAT II, automatic selection
Line Frequency 50 to 440 Hz
Power Usage 50 VA max
Environmental
Characteristics
Ambient Temperature Operating 0 °C to +55 °C
Non-operating -40 °C to +70 °C
Humidity Operating 95% RH at 40 °C for 24 hr
Non-operating 90% RH at 65 °C for 24 hr
Altitude Operating to 4,570 m (15,00 ft)
Non-operating to 15,244 m (50,000 ft)
Vibration HP/Agilent class B1
Shock HP/Agilent class B1
Pollution degree2 Normally only dry non-conductive pollution occurs. Occasionally a temporary
conductivity caused by condensation must be expected.
Indoor use only This instrument is rated for indoor use only
Installation categories
CAT I: Mains isolated
CAT II: Line voltage in appliance and to wall outlet
To Next Page
Loading...
