Getting Started
Agilent 6400 Series Triple Quadrupole LC/MS Quick Start Guide 5
Getting Started
Install the Triple Quadrupole LC/MS hardware and software
Use the Installation Guide to install the hardware and software and verify
performance.
Set up, run, and analyze samples
The roadmap below shows you the steps to set up and run a batch of samples from
start to finish. Follow the instructions on the next pages to get started and to learn
where to find the information to help you with each step in this roadmap.
Start
Here!
Set up, run
and analyze
samples
3 Prepare the
Triple Quad
instrument.
1 Start the
Data
Acquisition
software.
2 Prepare the
LC modules.
4 Set up and
run an
acquisition
method.
5 Review
results with
Qualitative
Analysis.
6 Analyze data
with
Quantitative
Analysis.
To Next Page
Loading...
