To Next Page
B
BillSep 22, 2026
How do I label a peak?
How do I label a peak?
Explains symbols used on the instrument for user information.
Steps for safely removing the spectrometer from its shipping container.
Details standard included items and available optional configurations.
Instructions for installing accessories and identifying instrument components.
Procedure for connecting the spectrometer to the power supply and AC outlet.
Guidance on operating environment, software setup, and instrument power control.
Procedure for safely powering down the Agilent Cary 630 FTIR system.
Procedures for verifying instrument performance and interpreting diagnostic values.
Details on signal-to-noise, stability, and laser frequency calibration tests.
Procedure for switching between different sampling accessories for analysis.
Using the Diamond ATR accessory for sample analysis, including cleaning.
Guide to using the ZnSe ATR accessory for various sample types and cleaning.
Instructions for analyzing samples with the Germanium ATR accessory.
Using the multi-bounce ZnSe ATR for enhanced sensitivity and analysis.
Analysis of solids, liquids, and gases using the transmission accessory.
Using 10 and 45 degree SRAs for reflectance measurements.
Guide to analyzing liquid, paste, and gel samples with the TumblIR accessory.
Using the DialPath accessory for liquid analysis with multiple pathlengths.
Performing quantitative and qualitative analysis on powdered and solid samples.
Procedure for cleaning the exterior of the Agilent Cary 630 FTIR system.
Instructions for replacing the desiccant cartridge to manage humidity.
Steps for safely removing and replacing the optical windows of the system.
Procedure for replacing the infrared source, noting its typical lifetime.
List of part numbers and descriptions for various sampling accessories.
Details interferometer geometry, resolution, source, accessories, and dimensions.
Covers laser safety, ICES/NMB-001 compliance, and electromagnetic compatibility.
Specifies temperature, humidity, and altitude limits for system operation.
General| Power Requirements | 100-240 VAC, 50/60 Hz |
|---|---|
| Weight | 6.8 kg |
| Detector | DLATGS |
| Interferometer | Michelson |
| Detector Type | DTGS (Deuterated Triglycine Sulfate) |
