Getting Started
Agilent Cary 630 FTIR Spectrometer User’s Guide 13
Installation
The Cary 630 FTIR is designed to be completely customer-installable.
Install your Cary 630 according to the guide lines below. For a quick
reference guide refer to the installation card.
Components
Attaching the sampling accessory or interface is necessary in order to
ensure proper working order of the Cary 630 FTIR. To install any of
your accessories:
1 Press the release lever outward
2 The accessory is meant to slide into the recessed or dovetailed
area. This is done by matching the dovetail to the front plate and
sliding in a downward fashion. (Figure 1)
3 The accessory is in place when the release lever snaps back into
place.
Figure 1. Press the release lever of the Cary 630 Engine outwards before sliding
the accessory into place.
To Next Page
Loading...
