Agilent Technologies Varian CP-8400

Varian, Inc.
2700 Mitchell Drive
Walnut Creek, CA 94598-1675/USA
Varian, Inc. 2003 Printed in the Netherlands 03-914852-00:Rev. 4.1
CP-8400 AutoSampler and
CP-8410 AutoInjector
Operator's Manual
NOTICE: Varian, Inc. was acquired by Agilent
Technologies in May 2010. This document is provided
as a courtesy but is no longer kept current and thus
will contain historical references to Varian. For more
information, go to www.agilent.com/chem.

Agilent Technologies Varian CP-8400 Specifications

General

Brand	Agilent Technologies
Model	Varian CP-8400
Category	Laboratory Equipment
Language	English

Summary

Introduction

Installing the CP-84008410

Configuring SPME Mode

Setup and Calibration

Vial Calibration

Calibrates vial positions using a specific tool for accurate sample placement.

Injector Calibration

Sets up injector positions for accurate sample aspiration and injection.

Operation

Automation Setup

Configures single method and method sequence automation modes for sample runs.

Method and Sampling Modes

Details method parameters and various sampling modes for analysis execution.

Instrument Menu and Status

Accesses system settings, status, and maintenance options for the instrument.

Special Uses

DualDuplicate Injection Modes

Explains performing two injections from one or two vials into two injectors.

Assigning Methods to Vial Ranges

Links specific methods to ranges of vials for automated sequences.

Automated Internal Standard Metering

Describes how the system automatically meters internal standards before sample injection.

Priority Sample Execution

Allows interrupting automation to run urgent samples.