Agilent Technologies Varian CP-8410 - User Manual

Varian, Inc.
2700 Mitchell Drive
Walnut Creek, CA 94598-1675/USA
Varian, Inc. 2003 Printed in the Netherlands 03-914852-00:Rev. 4.1
CP-8400 AutoSampler and
CP-8410 AutoInjector
Operator's Manual
NOTICE: Varian, Inc. was acquired by Agilent
Technologies in May 2010. This document is provided
as a courtesy but is no longer kept current and thus
will contain historical references to Varian. For more
information, go to www.agilent.com/chem.

Agilent Technologies Varian CP-8410 Specifications

General

Type	Gas Chromatograph
Manufacturer	Agilent Technologies
Model	Varian CP-8410
Category	Laboratory Equipment
Injection Port Temperature Range	Up to 400°C
Detector Type	FID (Flame Ionization Detector)
Column Oven Temperature Range	Ambient to 450°C
Carrier Gas	Helium, Nitrogen, Hydrogen
Compatibility	Autosamplers

Summary

Introduction

Installing the CP-8400;8410

Power and Environmental Requirements

Specifies power needs and operating environmental conditions for the autosampler.

Configuring SPME Mode

Setup and Calibration

Vial and Injector Calibration Procedures

Details calibration for vial positions, the calibration tool, and injector positions.

Operation

Parameters and Quick Reference

Overview of parameter layout and access for quick configuration.

Automation Setup

Details parameters for Single Method and Method Sequence automation.

Injection Modes and Methods

Discusses preprogrammed injection modes and user-defined method setup.

Special Uses

Dual;Duplicate Injection Modes

Discusses running injections into two injectors simultaneously (Dual Run, Duplicate Run).

Method Assignment and Priority Samples

Covers assigning methods to ranges and interrupting automation for priority samples.