Getting Started
16 Agilent Cary 630 FTIR Spectrometer User’s Guide
Environment
CAUTION
Your Cary 630 FTIR must be kept away from hot surfaces and sources of
electromagnetic interference.
MicroLab PC software
Your Cary 630 FTIR is supplied with Agilent MicroLab PC software.
For instructions on installing the software, see the Agilent MicroLab
PC Software User’s Guide. The software manual is located on the
Software installation CD. It provides more in depth information about
logging on, managing users, editing methods and reviewing data.
Turning On the Instrument
To turn on the instrument:
1 Press the power button of the Cary 630 FTIR system and hold for
two (2) seconds. Initially, the light will flash between red and
green while the firmware is being loaded. This process should take
less than 15 seconds. When the LED light illuminates solid green,
the instrument is now ready to use.
2 The spectrometer must have a warmup period of 5 minutes before
reliable analysis may begin.
When finished using the instrument, press the green power button
again to turn off the system. The LED light will turn red.
Power switch LED status
The power button contains a two-colored LED. The color displayed on
the LED can indicate the state of the system. The table below lists the
colors of the LED and the status of the instrument.
To Next Page
Loading...
