Agilent Technologies 6631B

Manual Updates
The following updates have been made to this manual since the November 1997 printing indicated on the
Printing History page.
7/8/99
Additional information about CV mode operation has been added to page 20.
A note has been added to Table A-1 for the Ripple and Noise specifications and a correction has been
made for Model Agilent 6631B.
Steps 22 and 23 on page 61 under Low Range Current Measurement Calibration have been switched.
1/7/00
All references to HP have been changed to Agilent.
All references to HP-IB have been changed to GPIB.
A note about magnetic fields has been added to page 22.
On page 49 the model reference for note 2 has been corrected.
2/21/01
A note has been added to Table A-1 for the Programming Accuracy specification.
Information about Option 760 has been added to Table A-1, note 5
The values for Average Programming Resolution, Current in table A-2 have been adjusted.
5/01/02
Step 19 on page 56 under Negative Current Programming Calibration has been corrected.
10/2/03
The Ripple and Noise specification for Model 6634B has changed in table A-1.
3/9/04
The ac input ratings and fuse information has been updated as per IEC 61010-1 requirements throughout
the manual.
The Declaration of Conformity has been updated on page 5.