17
2
General Information
Document Orientation
This manual describes the operation of the Agilent Model 66332A Dynamic Measurement DC Source
and the Agilent Model 6631B/6632B/6633B/6634B System DC Power Supply. Unless otherwise noted,
both units will be referred to by the description "dc source" throughout this manual. The following
documents are shipped with your dc source:
♦ a User’s Guide (this document), contains installation, checkout, and front panel information
♦ a Programming Guide, contains detailed GPIB programming information
♦ an Agilent VXIplug&play instrument driver, for Windows 95 and Windows NT 4.0
The following Getting Started Map will help you find the information you need to complete the specific
task that you want to accomplish. Refer to the table of contents or index of each guide for a complete list
of the information contained within.
Getting Started Map
Task Where to find information
Installing the unit
Line voltage connections
Computer connections
Load connections
User’s Guide
Checking out the unit
Verifying proper operation
Using the front panel
Calibrating the unit
User’s Guide
Using the front panel
Front panel keys
Front panel examples
User’s Guide
Using the programming interface
GPIB interface
RS-232 interface
User’s Guide
Programming Guide
Programming the unit using SCPI (and Compatibility)
commands
SCPI commands
SCPI programming examples
Compatibility language
Programming Guide
Installing the VXIplug&play instrument driver
NOTE: The driver must be installed on your pc to access
the on-line information. Drivers are available on the web at
www.agilent.com/find/drivers.
Programming Guide
To Next Page
Loading...
Need help?
General
